This connector will mate with female connectors that have a 2.54mm pitch (pin spacing) This 2x36 pin header is intended to assist with prototyping. Whether you need to connect or solder, these headers are breakaway: meaning they can be broken apart easily.

Type K Thermocouple Temperature Sensor. 1 meter length. A general purpose thermocouple with probes for temperature sensing.

18/2 AWG Unshielded Cable for use in power supply connections.

Use this SHIELDED 2 conductor 22 AWG stranded cable for signal level connection. This cable will be protected from interference

This connector will mate with male headers that have a 2.54mm pitch (pin spacing). This assembly includes three (3) crimp pins and the three position housing. The housing has a flap that keeps the crimp pin from sliding out. The crimp pins can be crimped with a special crimper, or a standard pair of needle nose pliers. This connector works well with our unshielded three (3) conductor cable.

Use this SHIELDED 3 conductor 22 AWG stranded cable for signal level connection. This cable will be protected from interference

Use this cable for signal level or low power. We use this cable for the 3D Printer end stops to and from the 3D Printer Mainboard. The cable is unshielded and the conductors are stranded 22 gauge.

Use this SHIELDED 4 conductor 18 AWG stranded cable for signal level connection. This cable will be protected from interference

We use this connector with our 2.5 amp stepping motor driver that is used to drive 3D Printers. Our standard 4 conductor cable is perfect for this connector. The crimp pins can be used with wire sizes between 18-24 gauge (AWG). The pitch (spacing between pins) is 3.96mm or .155 inches.

Insert a filament and a bead of plastic comes out of the other end. This extruder can be installed on machines that have 3 axes of movement. Includes hot end, nozzle, fan, heat sink, stepper motor, heating element and all hardware to assemble.

This board controls all of the functions of the extruder. Features of this controller include: monitoring the temperature of the hot end, heating the hot end, providing current to a heated table, fan control, and communicates to and from the 3D Printer main board and Arduino Mega pair.

This stepping motor driver plugs conveniently into the 3D Printer main board. No cables from the main board to this board is necessary.

This board plugs into the Arduino Mega 2560 and provides connections to the stepping motor drivers, end stops, RS-485, a ribbon connector for other functions, and a simple 12 volt terminal.

This board becomes the brain of the 3D Printer and serves as the main interface to the computer. This high end Arduino product can be used for many applications.