[ Log In ]
[ Register ]

Question #: 13604

Question: Can a sample be sent and or brought to you for confirmation of the end results when cutting carpet tile and or hard surface tile?

Current Solution

The blackTooth will cut acrylic very easily. The type of acrylic (cast or extruded) is not important since the acrylic itself has 100% absorption with CO2 lasers. Any plastic retailer, even the home improvements stores will have sheets of acrylic.

Avoid using plastics that will off-gas toxic and corrosive fumes. One example is PVC which is Polyvinyl Chloride. The burning of that material will exhaust chloride into the air and combine with the hydrogen in the air causing a chemical reaction yielding hydrochloric acid which is corrosive and highly toxic to humans.

Always read the MSDS (Material Safety Data Sheet) for any material that you intend to burn with the CO2 laser.


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.