[ Log In ]
[ Register ]

Question #: 13955

Question: the computer is not able to wrk properly with the upgraded laser tube and power board and has an outdated software instilation.

Current Solution

Is this a CO2 laser tube? CO2 laser tubes are not typically associated with the laser controller. The laser tube is powered by a laser tube power supply which is controlled by a simple digital on/off or PWM signal.

If you got a higher powered laser tube, then the power supply for the laser tube needs to be correctly wired to the laser controller.


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.