[ Log In ]
[ Register ]

Question #: 94

Question: What are the jumpers used for on the c-10 breakout board

Current Solution

there are 2 sets of jumpers, one set is to set the com or common to ground or 5v. if you set it to 1-2 then comm is equal to ground. 2-3 equal to plus 5v. You can locate the comm terminals between pins 2-9. Then there is another jumper to set pins 2-9 to input or output if you set it between 1-2 it is output. If you set it between 2-3 it is input.


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.