[ Log In ]
[ Register ]
Bracket Set for the 0.7
Bracket Set for the 0.7
Price Options Your Cart $0.00
Bracket Set for the 0.7" x 0.6" Cable Carrier
$7.00
Introduction:

These are the brackets for each side of the 0.7" x 0.6" cable carrier. This set includes both end brackets. The brackets are used to fasten the cable carrier to the machine, one end at a stable point and the other end at the moving part. You will need one bracket set for each axis that will have a cable carrier.

Description:
Related Tutorials
Thumbnail: How to modify the cable carrier.  Removing the pin. Cable Carrier Demonstration and Modification Instructions
We started carrying these new cable carriers that contain yellow hinge pins. The construction of the cable carrier is sturdy, but still has great flexibility. With this sturdiness comes the non-intuitive method of modifying the cable carrier. How is it possible to remove links, or put two cable carriers together? Also, how many wires, cables and tubes fit within the cable carriers.
Two motors moving in opposite directions How To Have Two Motors on a Single Axis Spinning in Opposite Directions on a CNC Machine
In this tutorial we will demonstrate how to have two motors on a single axis spinning in opposite directions with the use of a hex inverter.
Step 8: X-Axis Front and Back
This tutorial is dated, if you are considering a CNC for your personal use, we would highly recommend purchasing a kit that is very stable from our wide range of machines available. We are going to cheat and skip to the x-axis for a minute, well... actually 8 minutes since that's about how long the video is. The CNC router has a table, right? The flat piece that you put the stuff on to cut, right? Well, that piece has this thing called the gantry riding over it. How does that gantry move? It needs to hug this surface and requires a piece underneath. In other words, the gantry cannot move unless this surface is lifted above the ground to accommodate the gantry support and the motor underneath.