My BoB has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, instruct/book says term#2 to Pul- & term#3 to Dir-, sorry I'm lost

Pul+ is the Step+ and Pul- is the Step-. Pul is short for pulse. A pulse will create a step. Don't worry about the enable terminals. On the x-axis, pin #2 can go to pul- and pin #3 can go to dir-. The 5v will go to pul+ and dir+. The configuration for each axis for step will be active low and toggle active low for the dir on each axis to make it go in the direction desired. Next time, purchase the drivers from us and you will have fewer problems. Additional Information: Additional Information: Additional Information: Additional Information: Additional Information: Hi, I have an IHSS57-36-20 stepper motor with integrated driver (pulse mode) in my printer but it looks the paper moving distance is changing according to the paper tension. Has this version any encoder or I lose some steps? Thanks, John Additional Information: pin #2 can go to pul- and pin #3 can go to dir- Additional Information: pin #2 can go to pul- and pin #3 can go to dir- Additional Information: pin #2 can go to pul- and pin #3 can go to dir-