BuildYourCNC
Kupplungsnabe – 5/16" Bohrung
Kupplungsnabe – 5/16" Bohrung
Verfügbarkeit für Abholungen konnte nicht geladen werden
Diese Nabe kann an einer 1/4" Motorwelle oder einer 1/4" Spindel befestigt werden. Hinweis: Um einen vollständigen Kupplungssatz zu erstellen, benötigen Sie zwei Naben (eine für die Motorwelle und eine für das Spindelende) und eine Spinne. Diese Artikel werden nur angeboten, um Konfigurationen zu ermöglichen, die für starre Kupplungen nicht angeboten werden.
Teilen
Questions & Answers
Have a Question?
-
How long are the wires on the proximity switches you over
The NPN proximity switches we stock have 43" (1.09 meters) of cable and the PNP proximity switches we carry have 48" (1.21 meters) of cable.
-
For a stepper motor that requires 5.5 amps, would you recommend setting the stepper driver to 5.43 or 6 amps? Better to go lower or higher?
If your motor spec call for 5.5 amps, it is best to set the driver for the setting that matches that spec, or the next lowest value. This will allow the motor to run within its designed characteristics.
-
Do you offer or can recommend a place where I can buy the Drive Pulley for NEMA 43 Stepper Motor (1586 oz-in 3/4" single shaft) 5.5 Amps?
We don't offer those drive pullies with a 3/4" bore at the moment. We can supply them if you are willing to wait. If so, what is the pulley pitch, how many teeth and the width of the belt. Additional Information: Meant to say pulleys, not pullies.