BuildYourCNC
Coupling Hub - 5/16" Bore
Coupling Hub - 5/16" Bore
Couldn't load pickup availability
This hub can be fastened to a 1/4" motor shaft or a 1/4" lead screw. Note: To create a complete coupling set, you will need two hubs (one for the motor shaft and one for the lead screw end) and you will need one spider. These items are only offered to allow for any configurations that is not offered for rigid couplings.
Share
Questions & Answers
Have a Question?
-
How long are the wires on the proximity switches you over
The NPN proximity switches we stock have 43" (1.09 meters) of cable and the PNP proximity switches we carry have 48" (1.21 meters) of cable.
-
For a stepper motor that requires 5.5 amps, would you recommend setting the stepper driver to 5.43 or 6 amps? Better to go lower or higher?
If your motor spec call for 5.5 amps, it is best to set the driver for the setting that matches that spec, or the next lowest value. This will allow the motor to run within its designed characteristics.
-
Do you offer or can recommend a place where I can buy the Drive Pulley for NEMA 43 Stepper Motor (1586 oz-in 3/4" single shaft) 5.5 Amps?
We don't offer those drive pullies with a 3/4" bore at the moment. We can supply them if you are willing to wait. If so, what is the pulley pitch, how many teeth and the width of the belt. Additional Information: Meant to say pulleys, not pullies.