Tech Video Clips
Brief Description of a Relay
A relay is a device that accepts a voltage to close or open (normally closed or normally open, or both) an internal switch in the relay. That is to say,...
Brief Description of a Relay
A relay is a device that accepts a voltage to close or open (normally closed or normally open, or both) an internal switch in the relay. That is to say,...
Breadboard the LED to Microcontroller with Resi...
Physically wiring the circuit for an LED (Light Emitting Diode) to a microcontroller and a resistor so we can turn the LED on and off.
Breadboard the LED to Microcontroller with Resi...
Physically wiring the circuit for an LED (Light Emitting Diode) to a microcontroller and a resistor so we can turn the LED on and off.
Breadboarding: Putting the Accelerometer on the...
Since this Freescale accelerometer requires a different voltage than the AVR microcontroller, another voltage regulator is used (Maxim MAX604). The MAX604 will be positioned on the other extreme side of...
Breadboarding: Putting the Accelerometer on the...
Since this Freescale accelerometer requires a different voltage than the AVR microcontroller, another voltage regulator is used (Maxim MAX604). The MAX604 will be positioned on the other extreme side of...
Breadboarding: Powering the Microcontroller Cir...
The USB from the computer can be used to power the microcontroller circuit. The USB power is already a regulated power source, but another regulator can be connected with this...
Breadboarding: Powering the Microcontroller Cir...
The USB from the computer can be used to power the microcontroller circuit. The USB power is already a regulated power source, but another regulator can be connected with this...
Breadboarding: Powering the Microcontroller Cir...
A wall adapter can be used to power the microcontroller circuit. It is recommended to use a voltage regulator with this wall adapter to insure that the proper voltage is...
Breadboarding: Powering the Microcontroller Cir...
A wall adapter can be used to power the microcontroller circuit. It is recommended to use a voltage regulator with this wall adapter to insure that the proper voltage is...
Breadboarding: Potentiometer (Voltage Divider) ...
The center lead (Vout) of the potentiometer is connected to the ADC pin 0. The potentiometer's outer leads are connected to ground (GND) and 5V (VCC). These connections create the...
Breadboarding: Potentiometer (Voltage Divider) ...
The center lead (Vout) of the potentiometer is connected to the ADC pin 0. The potentiometer's outer leads are connected to ground (GND) and 5V (VCC). These connections create the...