Tech Video Clips
Breadboarding: How to Connect the 7805 Voltage ...
The 7805 voltage regulator is connected to a breadboard to provide 5 volts to the circuit. Two capacitors are connected to the voltage regulator, 10uf (microfarad) on the input and...
Breadboarding: How to Connect the 7805 Voltage ...
The 7805 voltage regulator is connected to a breadboard to provide 5 volts to the circuit. Two capacitors are connected to the voltage regulator, 10uf (microfarad) on the input and...
Breadboarding: connecting Two LEDs and One Push...
Two LEDs and one push button is connected to an AVR microcontroller on PORTB. The LEDs are connected to pin 0 and pin 1. The push button is connected to...
Breadboarding: connecting Two LEDs and One Push...
Two LEDs and one push button is connected to an AVR microcontroller on PORTB. The LEDs are connected to pin 0 and pin 1. The push button is connected to...
Breadboarding: Connecting Two Analog Signals to...
To convert more than one analog signal using the ADC, multiple channels must be used. In this case, an accelerometer will be connected to channel 0 and channel 1 of...
Breadboarding: Connecting Two Analog Signals to...
To convert more than one analog signal using the ADC, multiple channels must be used. In this case, an accelerometer will be connected to channel 0 and channel 1 of...
Breadboarding: Connecting the TX Pin from a Mic...
For a microcontroller to be able to transmit, a wire must be connected to the TX pin of that microcontroller and this wire should be connected to the RX pin...
Breadboarding: Connecting the TX Pin from a Mic...
For a microcontroller to be able to transmit, a wire must be connected to the TX pin of that microcontroller and this wire should be connected to the RX pin...
Breadboarding: Connecting the Hobby Servo to th...
The hobby servo is connected to the microcontroller using three wires, the VCC, GND and signal wire. The signal wire is connected to the OCR1A pin of the AVR microcontroller...
Breadboarding: Connecting the Hobby Servo to th...
The hobby servo is connected to the microcontroller using three wires, the VCC, GND and signal wire. The signal wire is connected to the OCR1A pin of the AVR microcontroller...
Breadboarding: Connecting power to the Microcon...
The VCC pin is connected to the + power rail on the breadboard and the GND pin is connected to the - power rail. A .1uf capacitor should be connected...
Breadboarding: Connecting power to the Microcon...
The VCC pin is connected to the + power rail on the breadboard and the GND pin is connected to the - power rail. A .1uf capacitor should be connected...