Control high powered devices with this dual 24V relay.

This breakout board will connect the parallel port of your computer to the drivers that drive the motors. A relay is featured on this board so another device can be controlled on and off, such as the router/spindle.

Do you have a signal wire that you need to invert. This integrated circuit takes a low signal and brings it high, and takes a high signal and brings it low.

This Mach3 USB Controller will run Mach3 through a standard USB port on a PC. You can use Windows 10 and older Windows version 32-bit or 64-bit.

This is the cable pack for the Pokeys57CNC motion control board.

Adding limit switches and proximity sensors is best connected to a CNC with this PoOptoIn breakout board! This board will allow you to connect proximity switches even if they require a higher voltage. The inputs with this board are optically isolated so interference is isolated from these sensitive signals.

The relay board will turn on standard electrical devices up to 12 amps and 250 volts using a standard 5v signal.

PoKeys57CNC Mach4 and Mach3 motor controller can control up to 8 STEP/DIR signal driven motors (stepper motors, servo drives, etc.) in various applications. The device contains dedicated connectors for connections with motor drivers, pendants, (HD44780-compatible) LCD module, etc. Also 5 analog inputs with 12-bit resolution are available. The device also features four galvanically-isolated open-collector outputs and isolated 0 to 10 V analog output.