[ Log In ]
[ Register ]

Question #: 1142

Question: Attaching the aluminum rails to the table. Do you use a 1/4" or 5/16" drill bit?

Current Solution

I like to use a 3/8" drill bit to create the holes on a table to mount the rails to give the rails a bit of wiggle room to adjust the alignment of the rail.


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.