[ Log In ]
[ Register ]

Question #: 14616

Question: This question has been asked before: What happened to my Mach3 Motor Tune-up in the Configure tab, it has disappeared but had been there before. The previous answers were to go to config: motor tuning

Current Solution

Motor tuning is the third option down when you click the config menu option. I have never used the motor tuning dialog from anywhere else. If you are looking for the button to calibrate the axes, then go to the settings tab and click on the button that says "Set Steps per Unit".


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.