[ Log In ]
[ Register ]
YouTube Channel - 100,000 Subscribers Reached!!!
It blows my mind how many subscribers have shown their unwavering support! If you haven't already, check out our BuildYourCNC and Newbiehack YouTube channel. It's unbelievable how this niche has grown, and I am incredibly grateful for each one of you!

Question #: 14728

Question: Hi I am trying to activate Mach3 USB Controller Output Terminals to activate a plasma from a output relay. I have looked at the video and applied 24VDC to 24v and dcm and measured from 24v and out1 and get no voltage when activating torch on mach3. The output 1 or 2 does not work.

Current Solution

Take a look at these two videos that I created today on Instagram on the proper wiring of a relay to the Mach3 USB controller.


Don't forget to watch the initial video on the Mach3 USB outputs on the Mach3 USB product page (last video on that page):


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.