[ Log In ]
[ Register ]
NEW: CNC Router PLANS Available for all of our Newest CNC Models!! Click here to "Design Your CNC".

Question #: 2189

Question: Which software does one use to connect the vacuum suction relay to synchronise with the pick and place part

Current Solution

Their is no synchronization, between the software and the vacuum, besides the way that it is reading through the relay(on/off method).

The vacuum pump is controlled by a circuit that has a pressure sensor, not included, (similar circuits used in industrial applications carry a very high price due to their specialization. This circuit keeps a range of suction in the tank at all times so the picking can be at its best performance. The range of suction is controlled by two potentiometers (components that can be adjusted like a dial on a stereo) to maintain a high and low vacuum and only run the vacuum when the tank needs to be . This vacuum is shown in inches of mercury. The higher the inches of mercury (Hg), the higher the vacuum.

Respond:

Other Possible Solutions to this Question

Get Help with:
This Product
Orders
Tech Support
Sales
This Product
Order Query
Tech Support
Sales
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.