[ Log In ]
[ Register ]

Question #: 3505

Question: The online Blacktooth assembly instructions in step 16 show how to connect the LED headers to strands of ethernet wires. The terminal used to connect to the header is shown in the picture, but it does not state what the part number is. Is the connector to be used part number 20170 labeled "Two pin 2P SIL Housing"?

Current Solution

Yes, the header on the black LED panel used on the blackTooth uses the 2P sil housing into which two crimp pins will be inserted. The crimp pins will need to be crimped onto the ends of the ethernet cable wires.

Additional Information:


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.