[ Log In ]
[ Register ]

Question #: 13671

Question: I bought Mach 4 and Mach 3 USB Motion card STB4100. The installation Manual you direct me to is for installing board with Mach3. Where can I find directions for the combination of products I bought? The axis motors are held stationary by the magnets but when I try to jog an axis from mach 4 program, no movement.

Current Solution

I am not using a parallell port. I am using a USB.


Other Possible Solutions to this Question

Get Help with:
This Product
Tech Support
This Product
Order Query
Tech Support
Not logged in. Log In Register
Track Order(s)
View Order(s)
I Want to Schecule a One-On-One Paid Tech Support Session
Book an Appointment Pertaining to a BuildYourCNC Product (Free)
Ask a Quesion Below (Free):
Book an Appointment Pertaining Other Equipment ($60/half hour)
Book an Immedite Appointment Pertaining Other Equipment ($120/half hour)
Ask a Quesion Below (Free):
Waiting for response... I may not answer immediately, but I was notified on my cellular phone so my response is forthcoming. If I don't respond immediately, you can always go to the [My Account] page to see all of our chats at any time.